Table of Content:
1 Introduction
1.1 Trademarks
1.2 Foreword
1.3 A Message to Our Customers
2 Safety
2.1 Recognize Safety Information
2.2 Understand Signal Words
2.3 Follow Safety Instructions
2.4 Keep Riders Off Machine
2.5 Use Steps and Handholds Correctly
2.6 Hydraulic Hose Replacement
2.7 Practice Safe Maintenance
2.8 Prepare for Emergencies
2.9 Wear Protective Clothing
2.10 Handle Agricultural Chemicals Safely
2.11 Use Safety Lights and Devices
2.12 Use a Safety Chain
2.13 Follow Tire Recommendations
2.14 Tow Loads Safely
2.15 Observe Maximum Transport Speed
2.16 Avoid High-Pressure Fluids
2.17 Remove Paint Before Welding or Heating
2.18 Avoid Heating Near Pressurized Fluid Lines
2.19 Decommissioning ? Proper Recycling and Disposal of Fluids and Components
2.20 Store Attachments Safely
2.21 Replace Safety Signs
2.22 Stay Clear of Air System
2.23 Use a Signal Person
2.24 Operator Ability
2.25 Service Safely
2.26 Operate Safely
2.27 Service Tires Safely
2.28 Transport Safely
2.29 Safety Features
3 Safety Signs
3.1 Falling Wing
3.2 Avoid Runover
3.3 Falling from Height
3.4 Electrical Line Contact
3.5 Sudden Crushing Movement
3.6 Hydraulic Injection
3.7 Transport Guidelines
3.8 Transport Guidelines
3.9 Chemical Contact
4 Information Signs
4.1 Information Signs
5 Preparing the Tractor
5.1 Use Tractor Operator’s Manual
5.2 Calculate Minimum Tractor Weight for Safe Transport
5.3 Recommended Tractors
5.4 Set the Selective Control Valves
5.5 Raise and Lock the Quick-Hitch
5.6 Position Drawbar
5.7 Case Drain and Hydraulic Motor Requirements
5.8 Power Beyond Kits
6 Preparing the Air Drill
6.1 Before Use
6.2 Determine Tractor Drawbar and Implement Hitch Compatibility
6.3 Road Transport and Hillside Operation Compatibility
6.4 Calculate Maximum Commodity Weight for Road Transport?C650 Cart
6.5 Calculate Maximum Commodity Weight for Road Transport?C850 Cart
6.6 Calculate Tow-Behind (TBH) Commodity Cart and Implement Compatibility
6.7 Hillside Slope Chart
6.8 Implement and Commodity Weight Charts
6.9 Check the Active Wing Brace
6.10 Meter Setup
6.11 P660 Air Drill with 30.5 cm (12 in) Row Spacing/Meter Cartridge Diagram
6.12 P670 Air Drill with 25.4 cm (10 in) Row Spacing/Meter Cartridge Diagram
6.13 P670 Air Drill with 30.5 cm (12 in) Row Spacing/Meter Cartridge Diagram
6.14 Quick-Start Procedure?Display
7 Attaching and Detaching
7.1 Using Tractor and Air Drill Operator?s Manuals
7.2 Configuration Identification
7.3 Hand Signals
7.4 Attach Air Drill or Cart to Tractor
7.5 Hydraulic Motor Case Drain Requirements
7.6 Recommendations for Hydraulic Connections
7.7 Attach the Warning Light Harness
7.8 Connect SeedStar Monitor Harness
7.9 Attach C650/C850 Tow-Behind Cart to Air Drill
7.10 Check Hydraulic Control Functions
7.11 Detach Air Drill or Cart from Tractor
7.12 Detach Air Drill from C650/C850 Tow-Behind Cart
8 Transporting
8.1 Attach Safety Chains
8.2 Lighting and Marking (Configuration A)
8.3 Attach the Warning Light Harness
8.4 Keep Riders Off Machine
8.5 Convert from Field to Transport Position
8.6 Convert from Transport to Field Position
8.7 Position Hitch Jack for Transport
8.8 Transport Machine
8.9 Operation or Transport on Hillsides
8.10 Operation or Transport on Hillsides (Continued)
8.11 Fold the Wings
8.12 Unfold the Wings
9 Monitor Setup for Blockage System
9.1 Blockage System Overview
9.2 Configure the Towers
9.3 Blockage Delay Setup
9.4 Run Screen for Blockage
9.5 Blockage Reset
10 Monitor Setup for Air Drill
10.1 Home Page Overview
10.2 Packing Pressure Setup and Operation
10.3 Master Switch Configuration
10.4 Lift Kit Pressure Setup and Operation
10.5 System Pressure Setup
10.6 System Alarms Setup
10.7 System Diagnostics
11 Operating the Air Drill
11.1 Keep Riders Off Machine
11.2 Follow Safe Operating Procedures
11.3 Stay Clear of Air Hoses
11.4 Guidelines for Use
11.5 Opener Overview
11.6 Adjust the Packing Pressure
11.7 Opener Valve Block Overview and Opener Operation
11.8 Lift Kit Overview
11.9 Main Valve Block Overview
12 Lubrication and Maintenance
12.1 Lubricating and Maintaining Machine Safely
12.2 Inspect Lift Circuit Hoses
12.3 Multipurpose Extreme Pressure (EP) Grease
12.4 Alternative and Synthetic Lubricants
12.5 Lubricant Storage
12.6 Lubrication Symbols
12.7 Lubrication and Maintenance Intervals
13 Blockage Diagnostics
13.1 Tower Module Information
13.2 Master Module Information
14 Troubleshooting
14.1 Troubleshooting the Air Drill
14.2 Troubleshooting Blockage System
15 Servicing
15.1 Metric Bolt and Screw Torque Values
15.2 Unified Inch Bolt and Screw Torque Values
15.3 Metric Face Seal and O-Ring Stud End Fitting Torque Chart?Standard Applications
15.4 Metric Face Seal and O-Ring Stud End Fitting Torque Chart?Heavy-Duty Applications
15.5 SAE Face Seal and O-Ring Stud End Fitting Torque Chart?Standard Applications
15.6 SAE Face Seal and O-Ring Stud End Fitting Torque Chart?Heavy-Duty Applications
15.7 Face-Seal-Fitting Assembly and Installation?All Pressure Applications
15.8 Service Recommendations for Flare-Type Tube Fittings
15.9 Service Recommendations for Metric Series Four Bolt Flange Fitting
15.10 Service Recommendations for SAE Series Four Bolt Flange Fittings
15.11 Practice Safe Maintenance
15.12 Welding Near Electronic Control Units
15.13 Keep Electronic Control Unit Connectors Clean
15.14 Inspect Lift Circuit Hoses
15.15 Replacing Ground Engaging Tools
15.16 Work in Clean Area
15.17 Handle Agricultural Chemicals Safely
15.18 Hydraulic Hose Replacement
15.19 Service Tires Safely
15.20 Check Tire Pressure
15.21 Check Wheel Bolts and Nuts
15.22 Check Wheel Bearings
15.23 Check Opener Assembly Torque
15.24 Remove and Install Packer Wheel
15.25 Replace Opener Hub Assembly
15.26 Remove and Install Fertilizer Tip
15.27 Remove and Install Seed Tip
15.28 Clean Air Tower
15.29 Bleed the Flow-Through Hydraulic Hoses?Tow-Behind Air Drill Only
15.30 Bleed the Brake Hydraulic Hose?Tow-Behind Air Drill Only
15.31 Systematic Approach to Air Run Identification?1910, C650, and C850 Tow-Behind Cart with Dual Blower System
15.32 Remove Air Hose Blockage
15.33 Air Hose Routing Identification
16 Storing
16.1 Prepare for Storage
16.2 Remove From Storage
17 Specifications
17.1 Specifications
17.2 Record Serial Number
17.3 Keep Proof of Ownership
17.4 Keep Machines Secure
18 Index
19 John Deere Service Literature Available
19.1 Technical Information
20 John Deere Service Keeps You on the Job
20.1 John Deere Parts
20.2 The Right Tools
20.3 Well-Trained Technicians
20.4 Prompt Service
