John Deere 3320, 3520, 3720 Compact Utility Tractors Operator Manuals OMLVU26141

Table of Content:

1 Introduction
1.1 Thank You for Purchasing a John Deere Product
1.2 Using Your Operator?s Manual
1.3 Machine Use
1.4 Special Messages
2 Product Identification
2.1 Record Identification Numbers
3 Table of Contents
4 Safety Labels
4.1 Safety Label Location
4.2 Safety Label Location
4.3 Pictorial Safety Signs
4.4 WARNING KEEP RIDERS OFF – LVU13286
4.5 WARNING / CAUTION – MIU10773
4.6 CAUTION AVOID CRUSHING – LVU11641
4.7 Rollover Protection Certification Plate
4.8 Drawbar EEC Label
4.9 Wagon Hitch EEC Information
5 Safety
5.1 Recognize Safety Information
5.2 Understand Signal Words
5.3 Follow Safety Instructions
5.4 Prepare for Emergencies
5.5 Wear Protective Clothing
5.6 Protect Against Noise
5.7 Handle Fuel Safely – Avoid Fires
5.8 Fire Prevention
5.9 Use Foldable ROPS and Seat Belt Properly
5.10 Stay Clear of Rotating Drivelines
5.11 Use Steps and Handholds Correctly
5.12 Read Operator Manuals for ISOBUS Implements
5.13 Use Seat Belt Properly
5.14 Vibration
5.15 Operating the Tractor Safely
5.16 Avoid Backover Accidents
5.17 Limited Use in Forestry Operation
5.18 Operating the Loader Tractor Safely
5.19 Keep Riders Off Machine
5.20 Passenger Seat
5.21 Use Safety Lights and Devices
5.22 Towing Trailers and Implements Safely (Mass)
5.23 Use Caution On Slopes and Uneven Terrain
5.24 Freeing a Mired Machine
5.25 Avoid Contact with Agricultural Chemicals
5.26 Handle Agricultural Chemicals Safely
5.27 Handling Batteries Safely
5.28 Avoid Heating Near Pressurized Fluid Lines
5.29 Remove Paint Before Welding or Heating
5.30 Handle Electronic Components and Brackets Safely
5.31 Practice Safe Maintenance
5.32 Avoid Hot Exhaust
5.33 Work in a Ventilated Area
5.34 Support Machine Properly
5.35 Prevent Machine Runaway
5.36 Park Machine Safely
5.37 Transport Tractor Safely
5.38 Servicing Cooling System Safely
5.39 Service Accumulator Systems Safely
5.40 Service Tires Safety
5.41 Service Front-Wheel Drive Tractor Safely
5.42 Tightening Wheel Retaining Bolts / Nuts
5.43 Avoid High Pressure Fluids
5.44 Do Not Open High-Pressure Fuel System
5.45 Store Attachments Safely
5.46 Dispose of Waste Properly
6 Operating – Controls
6.1 Operator Station Controls (PowrReverser)
6.2 Operator Station Controls (eHydro No Cab)
6.3 Operator Station Controls (eHydro With Cab)
6.4 Floor Panel Controls
6.5 Air Temperature Controls
7 Operating
7.1 Daily Operating Checklist
7.2 Avoid Damage to Plastic and Painted Surfaces
7.3 Entering and Exiting Machine
7.4 Adjusting Seat (No Cab)
7.5 Adjusting Seat (Tractor With Cab)
7.6 Using Seat Belt
7.7 Using Rear Window
7.8 Cab Classification According to EN15695-1 (for Application of Crop Protection Chemicals and Liqui…
7.9 Using Temperature Controls
7.10 Adjusting Blower Speed
7.11 Adjusting Tilt Steering Wheel
7.12 Using Light Switch
7.13 Using Dome Light
7.14 Using Key Switch
7.15 Using the Instrument Panel
7.16 Using Turn Signal Switch
7.17 Using Windshield Wiper and Washer
7.18 Using Display Mode Switch
7.19 Testing Safety Systems
7.20 Testing Neutral Start Switch (PowrReverser)
7.21 Testing Seat Switch (PowrReverser)
7.22 Testing Rear PTO Knob
7.23 Testing Rear PTO and Seat Switch Interface
7.24 Testing Mid-PTO and Seat Switch Interface
7.25 Testing Rear PTO and Park Brake Interface
7.26 Using Fuel Shut-Off Valve
7.27 Using Brake Pedals (PowrReverser)
7.28 Using Brake Pedals (eHydro)
7.29 Using Park Brake
7.30 Using Throttle Controls
7.31 Starting the Engine
7.32 Idling the Engine
7.33 Starting a Stalled Engine
7.34 Stopping the Machine
7.35 Operating PowrReverser Transmission
7.36 Driving Machine (PowrReverser)
7.37 Operating eHydro Transmission
7.38 Driving Machine (eHydro)
7.39 Using Cruise Control (eHydro With Standard Cruise Control)
7.40 Using Cruise Control (eHydro With Automotive Cruise Control Option)
7.41 Using SpeedMatch Option (eHydro)
7.42 Using MotionMatch (eHydro)
7.43 Using LoadMatch (eHydro)
7.44 Using Differential Lock
7.45 Using Mechanical Front Wheel Drive (MFWD)
7.46 Using the Power-Take-Off (PTO) Safely
7.47 Using Rear and Mid-PTO (Operator on Seat)
7.48 Using Rear PTO (Operator off Seat)
7.49 Using Drawbar Hitch
7.50 Using 3 Point Hitch
7.51 Connecting Implement Hydraulic Hoses
7.52 Using Dual Selective Control Valve (SCV) Lever
7.53 Using Dual Selective Control Valve (SCV) Lock Lever
7.54 Using I Rear Outlet Selective Control Valve (SCV)
7.55 Using I, II and III Rear Outlet Selective Control Valve (SCV) (If Equipped – Cab Models Only)
7.56 Using IV and V Rear Outlet Selective Control Valve (SCV)
7.57 Using Diverter II and III Rear Outlets
7.58 Using Accessory Electrical Outlet
7.59 Cab Exterior Cable Access
7.60 Selecting Ballast
7.61 Ballasting Machine
7.62 Using Front Tow Hitch
7.63 Transporting Machine on Trailer
7.64 Transporting Machine
7.65 Towing Loads
7.66 Using Safety Chain
7.67 Raising and Lowering Roll-Over Protective Structure (ROPS)
7.68 Using Seven-Terminal Outlet
7.69 Front Loader Installation
8 Replacement Parts
8.1 Service Literature
8.2 Parts
8.3 Part Numbers
9 Service Intervals
9.1 Servicing Your Machine
9.2 As Needed
9.3 After First 10 Hours
9.4 Every 10 Hours or Daily
9.5 Every 50 Hours
9.6 Every 200 Hours
9.7 Every 400 Hours
9.8 Every 600 Hours
9.9 Yearly
9.10 Every 1200 Hours
9.11 Every Two Years or 2000 Hours
10 Service Lubrication
10.1 Grease
10.2 Lubricating 3 Point Hitch
11 Service Engine
11.1 Avoid Fumes
11.2 Engine Oil
11.3 Checking Engine Speeds
11.4 Checking Engine Oil Level
11.5 Changing Engine Oil and Filter
11.6 Cleaning Dust Unloading Valve
11.7 Servicing Air Filter Element
11.8 Checking Air Filter Hose
11.9 Checking Air Restriction Indicator Light
11.10 Service Cooling System Safely
11.11 Checking Coolant Level
11.12 Recommended Engine Coolant
11.13 Servicing Cooling System
11.14 Checking Radiator Hoses
11.15 Adjusting Compressor Belt Tension
11.16 Servicing the Alternator Belt
11.17 Servicing Water Separator Sediment Bowl
11.18 Cleaning Fuel Filter Sediment Bowl and Replacing Filter
11.19 Replacing Fuel Filter
11.20 Fuel Injection Pump
11.21 Fuel Injection Nozzles
11.22 Cleaning Grille and Side Screens
11.23 Cleaning Radiator Screen and Fins
12 Service Transmission
12.1 Transmission and Hydraulic Oil
12.2 Checking Front Axle Oil Level
12.3 Changing Front Axle Oil
12.4 Adjusting Front Axle Thrust Bolt Torque
12.5 Checking Transmission Oil Level
12.6 Changing Transmission Oil and Hydraulic Suction Oil Filter
13 Service Steering & Brakes
13.1 Tractor Without Cab
13.2 Tractor With Cab
14 Service Electrical
14.1 Service the Battery Safely
14.2 Checking Battery Electrolyte Level
14.3 Removing and Installing Battery
14.4 Cleaning Battery and Terminals
14.5 Using Booster Battery
14.6 Replacing Headlight Bulb
14.7 Replacing Light Bulbs (Tractor With Cab)
14.8 Replacing Light Bulbs (Tractor Without Cab)
14.9 Replacing Fuses
15 Service Miscellaneous
15.1 Using Proper Fuel (Diesel)
15.2 Filling Fuel Tank
15.3 Lifting Points for Jacking up the Tractor
15.4 Raising and Lowering Hood
15.5 Servicing Air Conditioner
15.6 Cleaning Cab Air Filter
15.7 Checking Cab Rollover Protection System Installation
15.8 Checking Wheel Bolts and Hardware
15.9 Removing and Installing Wheels
15.10 Checking Tire Pressure
15.11 Selecting Front Tire Rolling Direction
15.12 Changing Wheel Spacing and Tread Width
15.13 Cleaning Plastic Surfaces
15.14 Cleaning and Repairing Metal Surfaces
16 Troubleshooting
16.1 Using Troubleshooting Chart
16.2 Engine
16.3 Electrical System
16.4 Heater and Air Conditioning System
16.5 Machine
16.6 Brakes
16.7 Steering
16.8 Error Codes
17 Storage
17.1 Storing Safety
17.2 Preparing Machine for Storage
17.3 Preparing Fuel and Engine For Storage
17.4 Removing Machine From Storage
18 Assembly
18.1 Delivery Instructions
18.2 Check Tire Pressure
18.3 Check Fluid Levels
18.4 Checking Machine Safety System
18.5 Check All Lights
18.6 Check Wheel Bolt Torque
18.7 Check Machine for Proper Ballast
19 Specifications
19.1 Engine
19.2 Electrical System
19.3 Fuel System
19.4 Drive Train
19.5 Hydraulic System
19.6 3 Point Hitch
19.7 Fluid Capacities
19.8 Ground Speeds (Forward and Reverse @ 2600 Engine RPM)
19.9 Front Tires
19.10 Front Tire Inflation Pressures
19.11 Rear Tires
19.12 Rear Tire Inflation Pressures
19.13 Tire Loads
19.14 Dimensions
19.15 Weight
19.16 Recommended Lubricants
19.17 Sound Level
19.18 PTO Options
19.19 Tire Combinations
19.20 Weight Specifications
19.21 Coupling Devices
19.22 Torque Values – Inch Fastener Hardware
19.23 Torque Values – Metric Hardware
20 Declaration of Conformity
20.1 EC Declaration of Conformity
21 Index
22 Notes
23 Notes
24 Service Statement
24.1 John Deere Parts
24.2 The Right Tools
24.3 Well-Trained Technicians
24.4 Prompt Service
25 Service Record
25.1 Record Service Dates